Headlight Reflector-to-Projector Retrofit Conversion
If you are looking to convert your halogen reflector housing to a true projector system, then check out our most popular conversions, past builds, or our pricing structure. Or if you are looking for a quad setup, check out our pricing structure.
Projector Swap-N-Upgrade: RetroQuick
Perfect for those that are looking to upgrade their OEM or aftermarket projectors to something better. Please be sure to check out our pricing structure.
Fog Light Reflector-to-Projector Retrofit Conversion
Tail Light Customization
Side Marker/Corner Marker Customization
Projector and Bulb Tuning
Retrofit Add-on & Headlight Customization
Add some spice to your headlights. Demon eyes, halos, or DRL’s, we have you covered! Check out our pricing structure.
If you do not want to keep your headlights chrome, paint them! Check out our pricing structure.
Restoration, Separation, and Re-Sealing
Foggy lens can severely hurt light output or can make your freshly done retrofits look, well, not so fresh. Or maybe there is some visible condensation and water damage and you need it cleaned up. Check out our pricing structure and schedule an appointment!
If you are trying to diagnose a driver failure, other minor issues, or if you need a full diagnostics, we can assist you with it. We will even take detailed photo/videos and have a full report for you to present to the parts supplier or company involved in your retrofit. Diagnostics fee starts at $55 an hour. Reports and photographic media will be provided at no additional cost.
Prices will vary depending on the vehicle. Typically, it will take 1-2 hours to remove and install a bumper. The current shop rate is $55/hour.
Automotive Lamp/Bulb Removal/Installation
This will be complimentary if we are taking off your bumper.
HID/LED Conversion Installation
If you are installing a new HID/LED kit or replacing an existing one, bring it over for proper installment and wire tucking. The cost is $55 an hour, plus the cost of any components that are needed.
If your headlights are too low, you are not going to see whats ahead of you. Or if your headlights are too high, you are probably getting “flashed”. Starting at $35/pair.
Halo, Demon Eye, DRL, or RGB Controller
If you want to connect the RGB or Switchback function for your headlights, or if your car did not come with a DRL, but the new set of headlight has one, we can help with that. We can get make a plug-n-play harness, or we can tap, splice, or even solder the wires to your factory harness. The hourly rate is $55 plus the cost for a harness and wire material. Or you can look through our pre-made harnesses here.